|
|
2009 Why might SolidWorks 2010 (or SolidWorks Explorer 2010) not start after rebooting the computer?
This is a known issue that only appears under the following conditions:
Microsoft Windows® XP 32-bit + specific Data Execution Prevention (DEP) settings.
The problem has been submitted to the SolidWorks Development team with the SPR below:
SPR 524232: SolidWorks 2010 no longer starts after the computer has been restarted. Note that using another user account to start SolidWorks via Run As allows SolidWorks to start until next reboot...
The workaround to this is as follows:
1. Right Mouse Button on My Computer and select Properties
2. On the Advanced tab>Performance>click Settings
3. Go to the Data Execution Prevention tab and most likely the setting "Turn on DEP for all programs and services except those I select" will be active
4. In the exception list see if Windows Explorer (explorer.exe) is listed. If it is, then select it and choose to Remove it from the list
5. OK out of all settings windows and reboot.
Special case:
When doing Step 3 above if the user currently has the option "Turn on DEP for essential Windows programs and services only" active, then do these alternate steps:
4. Toggle the other DEP option on so the list of possibly previously specified exceptions can be accessed
5. If Windows Explorer is in that exceptions list, then do the following process:
a. Remove Windows Explorer from the list
b. Reboot
c. Go back in the DEP interface again and set the option back to “Turn on DEP for essential Windows programs and services only"
d. Reboot once more.
針對這個問題，以上是原廠提出解釋，大伙等等看看sp1能否改善----- |
|
发表于 2009-11-20 14:42:00
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
收藏
转播
教程|习题|模型|技巧
点赞
拍砖
鲁公网安备 37028502190335号