求助！solidworks装配体导入adams仿真错误

ceshididi111

   经典图书

Solidworks的motion插件生成adams文件，导入adams后，点击仿真，结果报错

Suggested course of action:

Try to eliminate some or all of the redundant constraints in your model.

Note, however, that at least one warning was issued during model

assembly indicating that the initial relative configuration of markers

in constraints are not consistent with the constraints. This may be the

cause of this constraint analysis error. Try to eliminate these

warnings by specifying a consistent initial configuration of the system.

错误:   Simulation failure detected.

错误:   Simulation failure detected.

最后弹出  仿真失败

yuxiaojie0

很不错，顶一下！

temping

   经典图书

尝试消除模型中的部分或全部冗余约束。

但是，请注意，在建模过程中至少发出了一条警告

指示标记的初始相对配置的程序集

in约束与约束不一致。这可能是

此约束分析错误的原因。尽量消除这些问题

通过指定一致的系统初始配置发出警告。