凸轮采用Motion分析报错，望高手解答

Doubel

   经典图书

报错内容如下:

------------------------------------------------------------------------------- |                                 Model Title                                 | |=============================================================================| |                                                                             | |                         SOLIDWORKS Motion Mechanism                         | |                                                                             | -------------------------------------------------------------------------------

command: DEACTIVATE/GCON,ID=5

Deactivated MotionModel_3.a_____1_5, force/torque values will be zero in function-expression references.

command: DEACTIVATE/JPRIM,ID=1

Deactivated MotionModel_3.a_2_3, force/torque values will be zero in function-expression references.

command: DEACTIVATE/GCON,ID=5

****** Performing Dynamic Simulation using Gstiff I3 Integrator ******

Begin Simulation

Acceleration Computation: Singular Matrix at Time 0.000000000E+00. Equation with the largest imbalance: Part/4 X Force Imbalance = 8.000000000E+06 1) Check mass and inertia properties to ensure they are valid. 2) Make sure the choice of units is appropriate for the system.     Systems that have very small inertias may benefit from "small"     force units, e.g., dynes. 3) If DIFFs are present, provide different initial values for r2     (see DIFF statement definition).

End Simulation

Finished ----- Elapsed time = 2.58s,  CPU time = 5.09s,  197.12 凸轮模型如下：

knightwlf

顶一下，坐等高手！