你序列号也是没有公布或者是私人的！不然你不能下载地！

不是。在SW官方网上下载的。

你买的是正版的啊！
你公司真有钱！那直接卸掉360好了！

楼主支持原版的啊.....敬仰

我装的不需要CRACK

修复看看！软后重新Crack！

刚刚试过.还是不行..SW官方网上还没有发布SP1版

2009 Why might SolidWorks 2010 (or SolidWorks Explorer 2010) not start after rebooting the computer?
This is a known issue that only appears under the following conditions:
Microsoft Windows® XP 32-bit + specific Data Execution Prevention (DEP) settings.
The problem has been submitted to the SolidWorks Development team with the SPR below:
SPR 524232: SolidWorks 2010 no longer starts after the computer has been restarted. Note that using another user account to start SolidWorks via Run As allows SolidWorks to start until next reboot...

The workaround to this is as follows:
1. Right Mouse Button on My Computer and select Properties
2. On the Advanced tab>Performance>click Settings
3. Go to the Data Execution Prevention tab and most likely the setting "Turn on DEP for all programs and services except those I select" will be active
4. In the exception list see if Windows Explorer (explorer.exe) is listed. If it is, then select it and choose to Remove it from the list
5. OK out of all settings windows and reboot.

Special case:
When doing Step 3 above if the user currently has the option "Turn on DEP for essential Windows programs and services only" active, then do these alternate steps:
4. Toggle the other DEP option on so the list of possibly previously specified exceptions can be accessed
5. If Windows Explorer is in that exceptions list, then do the following process:
     a. Remove Windows Explorer from the list
     b. Reboot
     c. Go back in the DEP interface again and set the option back to “Turn on DEP for essential Windows programs and services only"
     d. Reboot once more.
針對這個問題，以上是原廠提出解釋，大伙等等看看sp1能否改善-----